Read this before assembly!
Carfully check for dirt and particles in all pipes and hoses. Also check for dirt inside the filter. At smallest hesitation, clean and wipe everything thoroughly before assembly!
Check hoses for deformations, cracks or other leakage. The clamps should be in good condition or to be replaced. Please note, when fitting BSR air filter, do not tighten the air filter to hard, be gentle. Check before and after testdrive that everything are tight and firm.


Installation instructions for Opti Flow filter kit.
JR filters are everlasting based on unique cotton fibres and will last for years if maintained properly.

Cleaning is recommended after approx 10 000 kilometres. Depending on season and how the car is used, cleaning may be required earlier than these intervals, in the spring and summer and when driving in highly polluted environments.
Clogged filters *) can cause engine malfunction and damage the engine.

During cleaning use only water based degreasing agents. Preferably environmental friendly.
Spirit based degreasing agents or strong detergents can harm the cotton fibres *)

Dismount the filter and spray the cleaning agent on the side where the air is goes in. Let the cleaning agent work for a couple of minutes. If the filter is very dirty an additional cleaning agent may help dissolve the dirt. Rinse the filter (from the back) under a tap or a shower using tepid water. Let the filter dry. Make sure the filter surface and the exterior rubber edge are undamaged.
If the vehicle is equipped with a coarse filter (leaf filter) before the air filter box, this needs be cleaned at the same time.

Finally, spray the entire filter with JR special oil. Do not overdose the oil so the filter is dripping or the engine can absorb filter oil.

Note. The filter material will be damaged by compressed air or high pressure washing.*)

Round universal filters are made from poluretan. The hose clamp must only be tightened until the filter is sealed and cannot come loose. If the clamp is too tight the clamp will cut into the material and the filter will crack. Large filters must be installed with some kind of support to ensure that the filter does not move.
Loose filters can damage the filter *)

*)in these cases, warranty is no longer valid.
Modified: 18 Jan 2003.